When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am about to adjust valves with the engine in.... thought maybe a magnetic version would ease the effort.
Not sure if this was done before, bored the tool to accept a magnet (3/8 x 1-1/2 axially magnetized, ~9lb pull force ). Cut the end off the old and used a simple ear clamp to hold it together. Will report back if it works.
12-16-2019, 07:27 PM
Modified Kirk tool?
That’s my one gripe with the tool, it’s a juggle to keep it in place.
