Paulyy

Does anyone have a digital drawing/sizes of the bottom of the bumper or any splitter (944) in general?

I want to DIY a splitter. So if anyone has any of the asking, I want to print an outline on an aluminium panel so i can cut it out perfectly and work out sizes ect.

So if someone has a digital drawing of the bottom of a bumper, i can draw up splitter sizing on that and print the outline. or if someone has a Digital drawing of a splitter (top view) i can get the bumper sizing off that and make my sizing.

Thanks

blade7

Take the front undertray off and draw around that, and transfer the mounting hole positions. I have a sheet of ply and that is how I'm going to make a splitter.

rlm328

I used the bumper, drew around it then moved the bumper 4-in for the splitter and traced it again. Then made a cut out for the wheels.

Paulyy

I didn't want to remove bumper.

I have 2.5m x 3m flat bed printer. I found drawings of the car anyway and did a life size print of the bumper area and used that as a template.