Local source for "bunny ear" vac fitting at rear of cylinder head?
08-20-2009, 05:32 PM
#1
Race Director
Thread Starter
Local source for "bunny ear" vac fitting at rear of cylinder head?
on the water elbow?
I stupidly knocked a wrench into mine and broke both "ears" off
I'm putting the car back together right now and would like to know if anyone had luck sourcing this part locally or if it interchanges with another type of car..
thanks
mke
I stupidly knocked a wrench into mine and broke both "ears" off
I'm putting the car back together right now and would like to know if anyone had luck sourcing this part locally or if it interchanges with another type of car..
thanks
mke
08-20-2009, 06:30 PM
#5
Addict
Rennlist Member
Rennlist Member
Join Date: May 2002
Location: Phoenix, AZ - NJ Runaway
Posts: 3,649
Likes: 0
Received 0 Likes
on
0 Posts
But, you can bypass it (connect the two lines) and not worry about it. It just helps, however minor, with cold start emissions and will not affect drivability in any way, shape or form.
08-20-2009, 10:02 PM
#7
Nordschleife Master
