Does anyone know where I can get a banjo bolt fitting, one that fits the top balance shaft to turbo. I think it is 14mm. I need one that converts to 3AN. Checked all the typical stores and can't find any. I think Lindsey sells one with there filter kit, but not sure if it is 3 or 4 AN.

Thanks

 

Check page 5.

http://64.202.180.37/files/metric.pdf

 

Awsome. You da man...

 

You will need a short banjo bolt, or a thick banjo fitting. The hole isnt threaded very deep. You can also use the stock bolt.

 

I think I'll just use the stock Bolt if it fits.
Thanks

 

I used the stock bolt and a fitting from BAT. Worked great!