Turbo to downpipe studs
03-06-2007, 11:36 PM
#1
Race Car
Thread Starter
Turbo to downpipe studs
What are the proper dimensions for these? I got 4 from Lindsey Racing, but they are longer than what I took off the old turbo. PET shows them even shorter than what was on there.
PET = 25mm
Old turbo = 45mm
LR pieces = 48mm
Also, there is an unthreaded portion of the stud that seems to bottom out on the turbo face before bottoming out inside the hole. Is this correct? Does it matter?
PET = 25mm
Old turbo = 45mm
LR pieces = 48mm
Also, there is an unthreaded portion of the stud that seems to bottom out on the turbo face before bottoming out inside the hole. Is this correct? Does it matter?
