Going Rate for 27/6
#1
Thread Starter
Addict
Rennlist Member
Rennlist Member
Joined: May 2002
Posts: 3,649
Likes: 0
From: Phoenix, AZ - NJ Runaway
FS: 27/6, saratoga, MAF.....
Hey guys, I have a freshly rebuilt 27/6 and I may be in "spare parts shelf" dump mode in the near future. What's the going rate for one? It has zero use on it since the rebuild. I also have a beautiful saratoga top, SFR MAF kit, a half dozen chip sets, and a handful of other things that may go as well.
Last edited by Jeremy Himsel; 04-04-2007 at 01:16 PM. Reason: update
#2
I'm bumping this up based on a fair bit of continued interest on the K27 I just sold. Jeremy still has this for sale and I believe is willing to sell it for what I sold mine - chime in if this is incorrect Jeremy.
#7
Thread Starter
Addict
Rennlist Member
Rennlist Member
Joined: May 2002
Posts: 3,649
Likes: 0
From: Phoenix, AZ - NJ Runaway
Hey Skip, thanks for the bump. I do appreciate it.
As most of you can see I'm pretty lazy when it comes to getting rid of this stuff but I'm pretty bored with my "other" car and need to get some respectable power out of it. I was just going to e-bay everything I have but if someone here is interested then it’ll save me the e-bay drama but I also know everyone is looking for a deal of the century.
Here’s just some of the stuff I have that I can think of (I’ve been collecting parts for a long time;
Freshly built 27/6 that I'm looking to get rid of for $600 shipped in the US. It was bought by a friend who totaled his car before he could install it and I picked it up from him for the parts shelf or maybe for another project. It was built by Turbo Performance in California. With my 3.0L going in and my Vitesse stage 2 motor tentatively sold I really have no use for it.
The last few saratoga tops went off on e-bay for $1,000 and one of them even had cracks in the plastic so it won't be going very cheap. The top is the later one in absolute perfect condition. I've yet to find one with less use or in nicer condition. The latches and seals are perfect. It's been sitting in a box and sunroof case for a while but I believe it's bronze tinted but I need to check. I was in a pretty nasty roll-over with another rennlister a few years ago and appreciate the thin sheet metal (or fiberglass) roof over my melon. I’m open to reasonable offers but don’t insult me with a 2 year old ebay link for one that went off for $355 without latches.
Vitesse 26/6 AFM chips for the later DME's (28 pin) for $175 shipped. They were installed for about 9 months and were replaced with a Vitesse MAF kit.
SFR MAF kit is a few years old but is the meter, j-pipe, hose connections, clamps, and the ARC-2 controller not the P1SC controller. $350 shipped OBO. It needs the MAF plug and a K&N.
Rennbay track/performance ball joint kit NIB(http://www.rennbay.com/trackperforma...-kit-p-35.html ) – $150 shipped
I know I have some more stuff lying around but I won’t be able to take an inventory until this weekend. If you want pictures I can send them but this weekend when I get off my *** and go into my attic.
Now I’d be willing to trade for C5 ZO6 parts if you have a few “lying” around. I’m looking for LG motorsports 1 7/8 LT headers and x-pipe, 205 AFR heads, and a 2 stage wet N20 set-up. I know it’s unlikely to find these on rennlist but at least the sales money is going to a good cause. A small blower for a 05 Lincoln Navigator, a current pair of harnesses, or some camber plates for the spec car would be a good trade as well.
As most of you can see I'm pretty lazy when it comes to getting rid of this stuff but I'm pretty bored with my "other" car and need to get some respectable power out of it. I was just going to e-bay everything I have but if someone here is interested then it’ll save me the e-bay drama but I also know everyone is looking for a deal of the century.
Here’s just some of the stuff I have that I can think of (I’ve been collecting parts for a long time;
Freshly built 27/6 that I'm looking to get rid of for $600 shipped in the US. It was bought by a friend who totaled his car before he could install it and I picked it up from him for the parts shelf or maybe for another project. It was built by Turbo Performance in California. With my 3.0L going in and my Vitesse stage 2 motor tentatively sold I really have no use for it.
The last few saratoga tops went off on e-bay for $1,000 and one of them even had cracks in the plastic so it won't be going very cheap. The top is the later one in absolute perfect condition. I've yet to find one with less use or in nicer condition. The latches and seals are perfect. It's been sitting in a box and sunroof case for a while but I believe it's bronze tinted but I need to check. I was in a pretty nasty roll-over with another rennlister a few years ago and appreciate the thin sheet metal (or fiberglass) roof over my melon. I’m open to reasonable offers but don’t insult me with a 2 year old ebay link for one that went off for $355 without latches.
Vitesse 26/6 AFM chips for the later DME's (28 pin) for $175 shipped. They were installed for about 9 months and were replaced with a Vitesse MAF kit.
SFR MAF kit is a few years old but is the meter, j-pipe, hose connections, clamps, and the ARC-2 controller not the P1SC controller. $350 shipped OBO. It needs the MAF plug and a K&N.
Rennbay track/performance ball joint kit NIB(http://www.rennbay.com/trackperforma...-kit-p-35.html ) – $150 shipped
I know I have some more stuff lying around but I won’t be able to take an inventory until this weekend. If you want pictures I can send them but this weekend when I get off my *** and go into my attic.
Now I’d be willing to trade for C5 ZO6 parts if you have a few “lying” around. I’m looking for LG motorsports 1 7/8 LT headers and x-pipe, 205 AFR heads, and a 2 stage wet N20 set-up. I know it’s unlikely to find these on rennlist but at least the sales money is going to a good cause. A small blower for a 05 Lincoln Navigator, a current pair of harnesses, or some camber plates for the spec car would be a good trade as well.
Last edited by Jeremy Himsel; 04-05-2007 at 11:57 PM.
Trending Topics
#9
Originally Posted by Jeremy Himsel
A small blower for a 05 Lincoln Navigator, a current pair of harnesses, or some camber plates for the spec car would be a good trade as well.
#14
Thread Starter
Addict
Rennlist Member
Rennlist Member
Joined: May 2002
Posts: 3,649
Likes: 0
From: Phoenix, AZ - NJ Runaway
Just for the hell of it I threw in some early spec car pics with my day labor at work..... THey car is about 2 feet off the ground in the first pic. We'ze got big nuts.