SMT6 fuel upper limit problem.
08-13-2006, 06:51 AM
#1
Advanced
Thread Starter
SMT6 fuel upper limit problem.
I can not set the "fuel upper limit" to 5V in global settings, everytime I try it automatically changes back to "fuel upper limit" 4V! This is a very dangerous behaviour, luckily i noticed it on my first full throttle run and didn't get that lean in the upper rpm's.
Have anyone else experienced the same problem?
Have anyone else experienced the same problem?
08-13-2006, 12:24 PM
#3
Advanced
Thread Starter
ok, so you think something is wrong in my global settings/wiring? Or could it be a hardware fault in my SMT6?
Another thing that annoyes me is that I can only get the O2 input on pin22 to read 0-1V(narrowband) and not 0-5V(wideband), should I be able to log a wideband O2? There is a "widebandO2" on/off in global settings, but it is greyed out in my windows program?
Another thing that annoyes me is that I can only get the O2 input on pin22 to read 0-1V(narrowband) and not 0-5V(wideband), should I be able to log a wideband O2? There is a "widebandO2" on/off in global settings, but it is greyed out in my windows program?
