baltik

was searching the archives for a good writeup but couldnt find anything

I will be installing a VDO vision in the lindsey din panel. Was thinking of tapping the klr line since that seems the easiest. is that a good place to tap or would I get a better reading for the engine bay.

Can some one give the right size for the tee to tap the klr?

thnks

oi-punx

You can check out my install HERE

Scroll down to the bottom of the page. I tied into the FPR and spliced the ashtray light for switched power.

This install is extremely clean when done right.

streckfu's

The KLR line is fine. You'll want a vacuum hose T with a 1/8" inside diameter. You won't get the plastic T to slide into the boost line as it is a hard line.