Recaro SRD - FS feeler
#1
Rennlist Member
Thread Starter
Join Date: Jan 2004
Location: Ventura, California
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
Recaro SRD - FS feeler
Hi Guys, just wanted to ping the forum and see if anyone was interested in a used Recaro SRD that came out of my Turbo S. I was going to put it on Ebay later this week, but it would be easier to sell to a Rennlister because the seat brackets and sliders are set up to fit a 944/951. Here are the details:
Driver's side Recaro SRD seat, approximately 5 years old, very good condition. Black bolsters with gray center fabric. Comes with sliders and base bracket to bolt right into any 944/951. Asking $475 + shipping. Located in So. Cal.
Email me for pictures if you are interested. For SoCal people, I can deliver the seat within the LA/Ventura/Orange County area.
-Greg W.
m5guy@aol.com
Driver's side Recaro SRD seat, approximately 5 years old, very good condition. Black bolsters with gray center fabric. Comes with sliders and base bracket to bolt right into any 944/951. Asking $475 + shipping. Located in So. Cal.
Email me for pictures if you are interested. For SoCal people, I can deliver the seat within the LA/Ventura/Orange County area.
-Greg W.
m5guy@aol.com
#2
Rennlist Member
Hi Greg
I am going to be in the Mkt for one but all black as that is what I currently have on the Drivers side
I believe that the seat itself is revresiable ( ie it can be either driver or pass ) ?
But I assume the seat rails may not ?
I had to mount mine on directly on the floor w/ an older style bracket because of the length of my
torso.. Head hit roof with helmet on :-)
Best of luck
Regards
Ed
I am going to be in the Mkt for one but all black as that is what I currently have on the Drivers side
I believe that the seat itself is revresiable ( ie it can be either driver or pass ) ?
But I assume the seat rails may not ?
I had to mount mine on directly on the floor w/ an older style bracket because of the length of my
torso.. Head hit roof with helmet on :-)
Best of luck
Regards
Ed
#3
Rennlist Member
Thread Starter
Join Date: Jan 2004
Location: Ventura, California
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
Correct, seat can fit either passenger or driver's side since it has the recliner **** on both sides. Slider brackets (which bolt to the bottom of the seat) can fit either side too. The base bracket (goes between floor and slider) has a specific orientation of drivers or passenger and cannot be swapped.
Best Regards,
GW
Best Regards,
GW
#4
Rennlist Member
Yes Greg
That was my problem, that base bracket
Had to ditch that, in order to get the height
Love that seat !!!
Regards
Ed
That was my problem, that base bracket
Had to ditch that, in order to get the height
Love that seat !!!
Regards
Ed