Songzzz

Anyone keen of importing my 86' 951 (Euro)? The car is in Taiwan. A lot of effort and money has been put into the car. Its a pain to part but I will be going home very soon (Singapore does not allow import of used cars).

Moded 951s are worthless in Taiwan, therefore, I am looking for overseas buyers willing to import the complete car. I will consider offers for parts listed below (exchange with stock).

Engine Mods and New parts
1. 968 3L Block
2. Modified water passage for 8V Head + LR Stage 1 option + new valves.
3. Stock Forged 968 Pistons with new rings. (CR 9:1)
4. Pauter Rods, stock-length.
5. Stock 3L crankshaft.
6. Complete rebuilt, less than 2K mileage.
7. Upated Oilpan.
8. Raceware Head studs.
9. New 8 x hydraulic lifters
10. Spec Aluminium Flywheel 6lbs.
11. Spec 6 puck Racing Clutch and Lightweight Pressure Plate.
12. Kokeln Club V Turbo
13. LR Blow off Valve
14. LR Dual Port Wastegate
15. LR Intercooler Stage 2
16. LR MAF and MAFterburner controller.
17. Uego Wideband O2 sensor with digital display.
18. Customed DME/KLR chips from Guru racing.
19. Kokeln Stainless Steel Intercooler Hard Pipes.
20. HKS EVC V
21. Replaced: water pump, all hoses, knock/water temp/oil pressure sensors, distributors, rpm sensors, fuel purge system, silicon vacuum lines, ISV and idle converted to Turbo S setup.
23. New Belts, Rollers .
24. MSD blaster coil, Performance wires.
25. LR Crankcase Breather kit.
26. Siemens 72lbs Injectors
27. C2T Fuel Pump.
28. New Tie Rods assembly.
29. New Motor Mounts (original)
30. New Power Steering Rack and Shaft.
31. Every single rubber hose under hood is new (less than 1K miles)
32. Lindsey Stainless 3" exhuast
33. Customised 4" to 5" muffler

Suspension and Brake Mods
1. 968 M030 Sway Bars (Front and Rear)
2. M030, Koni Yellows (Front and Rear)
3. Big Reds w/Pagid + Xdrilles rotors and koklen adaptors
4. X-drilled Zimmermann rotors for the rear.
5. 5/33 Brake Bias Proportional Valve.
6. Updated M030 Castor Block Mounts and Bolts.
7. New Spindles and Hubs.
8. Turbo S Master Brake Cylinder
8. H&R Front and Rear Spacers.

Exterior Mods
1. New Paint
2. GT Racing Spiltter
3. Limited C2 Turbo 17" wheels, 8J and 9.5J
4. 968 Door handles
5. 968 mirrors.
6. New tail and front signal lights.

Interior Mods
1. 968 10" spearkers and Door panels
2. White gauge clusters.
3. Autometer Boost gauge
4. Pivot Turbo Timer and Rev light.
5. Sony 10 disc changer with MBQuatz amplifier and speakers.
6. New shift boot trim, new shifter assy with Aluminium Turbo script and new armrest console.
7. Limited edition porsche design, light weight Momo Steering wheel.
8. Porsche logo Momo horn button.

more..... the list goes on .....

Anyway, I have full records of the car, receipts and instruction manuals. Serious enquiries only email: wee8ndrew@hotmail.com

Jason_86_951

To the top.................

Andrew, Sorry I didn't look you up this weekend. I was in Taipei, had lots of fun. Drank way too much at the Roxy99 and Roxy Vibe, but still managed to take in some sights Sat/Sun. Went to the National Palace Museum and that huge Jung-Hei-Chen Memorial (probally spelled wrong). Ate some killer Thai food Sat & Sun (so good I had to go back twice).
Taipei seems like a great place to live
Good luck on selling the car and your upcoming move.
Jason

OT: Any single guys that want to have fun, Taiwan is the place!!!!!!!!!!!!!!
The women there are out of this world!! (so good I had to marry one of them)

Duke

You got some sweeet parts there Songzzz!
Did you ever get that mysterious water leak sorted out?

eclou

I will be in Taipei in Sept. If anything is left by then I would be happy to swap for your Lindsey Intercooler and the Kokeln turbo with the stock IC and turbo

Peckster

You should do some research on what's required to ship it to the U.S., including import agreements, tarifs, shipping costs etc.

turbo951fan

Importing into the US is impossible. EPA/DOT etc restrictions. Canada no problem.

NZ951

I would like to swap my stock paint please

Actually... 968 mirrors, and sway bars, and intercooler if it falls through. I am interested, PM me if you want to trade. Are you going for the 911 when you move like you are tempted to?

shortyboy

10. Spec Aluminium Flywheel 6lbs.
11. Spec 6 puck Racing Clutch and Lightweight Pressure Plate.
32. Lindsey Stainless 3" exhuast

just wanted to know the prices on these and the shipping to hawaii.thanx

Eyal 951

how much for the boost gauge? and do you have an AF gauge?
~Eyal

v944god

How much for the full engine?

ACG

Songzzz,

I am also headed back to Spore for a 2 year assignment. I know how ya feel, as I will also have to leave my babies behind.

Cyrus951

Andrew,

I'm interested in the LR dual port wastegate, what's the total shipped to San Dimas, CA (91773)

NZ951

Also, if someone gets your pipes and does not have the stock ones... you can have mine for free if we end up trading anything...

Songzzz

Tks for the response. I have noted down all offers for the meantime, as my priority will be to sell the car complete. If there is no deal in 1 month, I will sell the parts and contact those interested.

Jason_86_951, No problem. Tks.

Duke, Problem Solved! Not sure about the cause(s) but I guess it could be due to the improper tightening of headstuds.

NZ951, I don't think I can afford a Porsche in Singapore, at least for now. The price tag on 88'951 is US$ 50K and you get to keep it for about 4 years, thereafter it has to be scrapped.


Tks to all.

v944god

Any word on selling the engine as well?