944 bucking under load... at a loss, please help!
05-11-2020, 08:29 PM
#16
7th Gear
Thread Starter
Join Date: Feb 2020
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Hey guys, checking back in on my earlier post. Still experiencing the same issues! What a pain!
The following have been replaced:
-Plugs/Wire
-TPS
-ICV
-Speed/Ref Sensors
A few of you have mentioned the DME chip - that will be the next thing i check out!
When you guys talk about logging... am i able to just plug my laptop in and capture the log using Rogue's software?
The following have been replaced:
-Plugs/Wire
-TPS
-ICV
-Speed/Ref Sensors
A few of you have mentioned the DME chip - that will be the next thing i check out!
When you guys talk about logging... am i able to just plug my laptop in and capture the log using Rogue's software?
05-14-2020, 01:18 PM
#18
Drifting
When you have the open DME on your table, take your phone camera & zoom in real close to the solder joints. Any lines like these will cause problems..
