Koni Conversion Dust Boot
08-07-2010, 01:25 PM
#1
Rennlist Member
Thread Starter
Koni Conversion Dust Boot
hey folks,
everyone may be aware of this, but Porsche has a dust boot for the strut caps for Koni shocks. they're part #999-703-355-40 and they fit great over the adjustment stud once you've installed the Koni adjustables.
everyone may be aware of this, but Porsche has a dust boot for the strut caps for Koni shocks. they're part #999-703-355-40 and they fit great over the adjustment stud once you've installed the Koni adjustables.
08-11-2010, 09:13 PM
#2
Advanced
Join Date: May 2010
Location: Phoenix, AZ
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
SWEET !!!! Didin't know they had those....It's the little things that count !!!!
Here's what I did, just drilled a hole in the original covers and slid the shipping cap on it...had to shorten it about 1/4 inch...but I'm still gettin the Porsche ones..only $1.50 each
Here's what I did, just drilled a hole in the original covers and slid the shipping cap on it...had to shorten it about 1/4 inch...but I'm still gettin the Porsche ones..only $1.50 each
08-11-2010, 09:22 PM
#3
Advanced
Join Date: May 2010
Location: Phoenix, AZ
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
While were on the topic of cool little doo hickeys....the cover for the idle adjustment screw...better get a few because when you take it off it breaks and won't go back on..think it was made that way...Porsche part number..930-110-520-00, it pushes on farther than that..just showed for picture...
