RMB touching bumper cover? & sound video
#1
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Just installed my RMB but its touching the bumper cover. I had a second pair of hands push it over while I tightened the clamps, but no change.
I have searched but found nothing.
Any ideas on how to align it properly so it doesn't touch the cover?
But it sounds friggin amazing.
Video:
https://www.youtube.com/watch?v=1tgz...ature=youtu.be
I have searched but found nothing.
Any ideas on how to align it properly so it doesn't touch the cover?
But it sounds friggin amazing.
Video:
https://www.youtube.com/watch?v=1tgz...ature=youtu.be
#2
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Faced with this I loosened the RMB to mid range mufflers and mid range mufflers to the cats and twisted the RMB until it is centered in the bumper cover. Then I tightened all the clamps.
#3
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Fixed, I put a tie strap on the mid pipe and pulled it to the passenger side, and another strap on the rmb pulling it to the drivers side. Tighten the clamps, took the straps off and it's all in place now.
Too bad it's raining or I would go out for a rip.
Too bad it's raining or I would go out for a rip.