G8RB8's 928S4 Resurrection Thread
#92
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I don't like the Momo shift ****. I ordered http://www.jageng.com/garage9/produc...roducts_id=609
and
http://www.jageng.com/garage9/produc...roducts_id=123
$172.95 shipped.
and
http://www.jageng.com/garage9/produc...roducts_id=123
$172.95 shipped.
#95
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Regarding the console insert around the shifter - I covered mine on the GTS (avatar) with OE Porsche black leather. Makes a very CLEAN installation with no bling!!
IF you need some leather, contact me - I have a lot of it from S4 rear quarter panels I removed.
Cheers,
Gary Knox
IF you need some leather, contact me - I have a lot of it from S4 rear quarter panels I removed.
Cheers,
Gary Knox
#96
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Regarding the console insert around the shifter - I covered mine on the GTS (avatar) with OE Porsche black leather. Makes a very CLEAN installation with no bling!!
IF you need some leather, contact me - I have a lot of it from S4 rear quarter panels I removed.
Cheers,
Gary Knox
IF you need some leather, contact me - I have a lot of it from S4 rear quarter panels I removed.
Cheers,
Gary Knox
Maybe I'll cover the blingy bit with leather and stick it on so it's easy to remove.
Thanks Gary
#98
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Back in the shop for the next round of catch up maintenance. Tranny, diff, and engine oil change. Getting the ride height set correctly then a full alignment.
I miss it already.
Last week I replaced the outside window seals. I'll post some pics of those when I get it back.
Ordered a new console lid.
I miss it already.
Last week I replaced the outside window seals. I'll post some pics of those when I get it back.
Ordered a new console lid.
#99
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Back at Gulf Performance catching up deferred maintenance. Tranny, diff, and engine oil. Prolly pull the valve covers to investigate noisy lifters. Look for other stuff to do on the next batch. A/C most likely.
#100
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Replaced all the lifters changed tranny, diff, and engine oil. and fixed the AC to the tune of $2000. Compressor was shot, dryer was shot, various O rings replaced.
Going for a shakedown cruise to Orlando.
Going for a shakedown cruise to Orlando.
#101
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Well, that was completely effortless. ~400 miles melted away like nothing. That trip in the Boxster is plenty one way in a day.
17.2 MPG over 469 Miles total, with A/C, almost all highway running 80+ with several sprints into triple digits.
17.2 MPG over 469 Miles total, with A/C, almost all highway running 80+ with several sprints into triple digits.
Last edited by G8RB8; 05-29-2013 at 11:22 PM. Reason: Mileage
#102
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Removed and properly installed the rear quarter window trim following this procedure from 928 Specialists. I added a twist by reconditioning the rubber at the same time, which made it ridiculously easy. I used HONDA SHIN ETSU GREASE as recommended here. I wish I hadn't put it off so long.
Also removed the old leaky, ugly antenna, which didn't work anyway and stuck on a fake fin a'la BMW. Looks good IMO.
Also removed the old leaky, ugly antenna, which didn't work anyway and stuck on a fake fin a'la BMW. Looks good IMO.
#105
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
G8RB8,
Nice car, do you mind sharing the place where you had it aligned and comment on their service?
I am changing my steering rack and that will be needed soon after it
Thanks
Nice car, do you mind sharing the place where you had it aligned and comment on their service?
I am changing my steering rack and that will be needed soon after it
Thanks