Kill Switch Fabrication Project… Version 2
12-31-2010, 07:23 PM
#1
Pro
Thread Starter
Join Date: Oct 2007
Location: Maryland
Posts: 737
Likes: 0
Received 0 Likes
on
0 Posts
Kill Switch Fabrication Project… Version 2
After fielding feedback from the Rennlist community, here’s version 2 of my kill switch fab project: 3-pole switch, accessible to corner works and myself and proper identification.
12-31-2010, 08:14 PM
#2
Former Vendor
Join Date: Feb 2004
Posts: 2,139
Likes: 0
Received 0 Likes
on
0 Posts
Don't know how accessible it will be for you all belted in a race seat and helmeted. Seems that it will be above your left shoulder a bit too far to reach easily.
However your track car project is looking very nicely done!
Cheers,
However your track car project is looking very nicely done!
Cheers,
01-01-2011, 12:57 AM
#3
Electron Wrangler
Lifetime Rennlist
Member
Lifetime Rennlist
Member
With appropriate wire & pulls it can be operated from outside and from the driver seat...
Good listening skills here... I think a much improved plan.
Sometimes running your ideas out in public changes your direction... immediately its tough to work through... but it really adds value by questioning assumptions - making you rethink etc...
Alan
Good listening skills here... I think a much improved plan.
Sometimes running your ideas out in public changes your direction... immediately its tough to work through... but it really adds value by questioning assumptions - making you rethink etc...
Alan
