Low oil pressure->Engine stalls->Normal ? [SOLVED!]
#46
Race Car
It is possible that the LH adapted to a problem so much that once the problem is fixed, the car can no longer run properly. This has happened to me in the past when an intake pipe by the intercooler blew off on one of my other cars (LH 2.4.2). I limped home like that and reconnected it, but the car would refuse to run properly. It ran fine after disconnecting/reconnecting the battery. The LH adapted so much to the huge air leak that once the leak was fixed, it could not adapt back. I didn't see you mention fixing any problems like this, however...
Dan
'91 928GT S/C 475hp/460lb.ft
Dan
'91 928GT S/C 475hp/460lb.ft
#47
Official Bay Area Patriot
Fuse 24 Assassin
Rennlist Member
Fuse 24 Assassin
Rennlist Member
What ground did you clean? You had indicated it in a prior post. There are some grounds below the airbox on the passenger side for the LH and EZK. Was it those?
#48
Instructor
Thread Starter
Join Date: Feb 2010
Location: Nearby Amsterdam (The Netherlands)
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
#49
Instructor
Thread Starter
Join Date: Feb 2010
Location: Nearby Amsterdam (The Netherlands)
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
It is possible that the LH adapted to a problem so much that once the problem is fixed, the car can no longer run properly. This has happened to me in the past when an intake pipe by the intercooler blew off on one of my other cars (LH 2.4.2). I limped home like that and reconnected it, but the car would refuse to run properly. It ran fine after disconnecting/reconnecting the battery. The LH adapted so much to the huge air leak that once the leak was fixed, it could not adapt back. I didn't see you mention fixing any problems like this, however...
Dan
'91 928GT S/C 475hp/460lb.ft
Dan
'91 928GT S/C 475hp/460lb.ft
#50
Official Bay Area Patriot
Fuse 24 Assassin
Rennlist Member
Fuse 24 Assassin
Rennlist Member
I should probably try and clean that one on mine too. I can't even get the wingnut off. It's like someone used loctite on it. That's probably not a good thing and corrosion may have froze it.