Notices
928 Forum 1978-1995
Sponsored by:
Sponsored by: 928 Specialists

Warning lights gone after pod removal/reinstall - ALAN, what did I do wrong??

Thread Tools
 
Search this Thread
 
Old 10-09-2009 | 06:14 AM
  #16  
VehiGAZ's Avatar
VehiGAZ
Thread Starter
Rennlist Member
 
Joined: Sep 2006
Posts: 1,556
Likes: 0
From: Oxford, CT
Default

Alan, I'm guessing you were looking at the second picture which shows the panel with the engine running already, because the lights you mentioned are all on in the top picture.

Bill, the CE light must have come later than 1989, as my manual does not show it.

So I'm fine then... PHEW! That's a load off my mind. Now I have to put the rest of it back together (did a little fishing in the center console while I was in there) and she's good to go.

Thanks all!!
Old 10-09-2009 | 10:51 AM
  #17  
Alan's Avatar
Alan
Electron Wrangler
Lifetime Rennlist
Member
 
Joined: Mar 2002
Posts: 13,435
Likes: 438
From: Phoenix AZ
Default

ahh yes I scrolled up to your picture while I was responding - BUT only as far as the second one...

Yes seems iike you are all OK... Bill didn't realize the earlier digi-dash cars didn't have the check engine light

Alan



Quick Reply: Warning lights gone after pod removal/reinstall - ALAN, what did I do wrong??



All times are GMT -3. The time now is 05:37 PM.