I need 2 cup 1 wheels. Anyone have spare? I do not need 4

 

Front or rear? Factory or aftermarket? Condition?

 

Hi there Mark!

Factory or aftermarket - either
need 9's
Prefer RDK, but not dead set on that (I'm not sure I have the units)
condition - good enough to go onto a daily driver, not bent or curbed too much, don't need to be perfect

 

I have 7's in decent cosmetic but not perfect condition. Maybe a 9 out of 10. Straight and true although one is a .00 and the other is a .01 both look the same from the outside different manufacturer but both OEM wheels. Didn't make PDK in 7 or 8's only 7.5's and 9's.

I was asking $300 plus shipping.

 

Sorry Anthony and thanks for correcting me. I guess I need 9's.

 

I have this pair for $150 but they need to be straightened.

 

That is very tempting. However,

Price $150
+ Straighten $200
+ ship $100
= $450 for the pair

 

How about $350 at your door?

 

Straight and true, shipped, that's a deal.

 

I will send them out today to be straightened.

 

Hey Mark (or anyone else for that matter),

Do you happen to have any bent, cracked or otherwise damaged tubo twists?

I’m only looking for one with a decent face, preferable the Mille aftermarket in 17”, but any will do.

I really need to keep the cost down, because I planning on making a subwoofer grill out of it... like these with a twist:

 

I have 3 options:
1. new aftermarket chrome 9x17 $125
2. used aftermarket 9x17 $50
3 used factory 10x18 $60

 

I take it the aftermarket 17 is the one with the rubber? That looks pretty good... any idea how much that would it cost to ship to Indiana (without rubber attached)?

You wouldn't happen to know anyone that could cut that in half to save of shipping?

 

It should cost about $25-30 to ship. Sorry but I don't know anyone to cut it in half.

 

Holy crap they made them in 10"??