1993 GTS rear reflector strip bulge...
#31
Owns the Streets
Needs Camber
Lifetime Rennlist
Member
Needs Camber
Lifetime Rennlist
Member
The same type body molding double-sided tape is used to hold the lower body cladding onto the car. The flex plastic pieces right behind the front wheel for example.
If those don't fall out in harsh freezing Canadian temps, then the fix will hold.
#32
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Hi Roger, nice to see your reply.
Just to add to my solution: it needs a real good epoxy glue. I had to do it over as the glue did not harden enough. Last bit was from Bison, that was and still is perfect. Also make the rear of the strip a bit rough (sanding) to get it to stick better. The plastic seems like PE and not much sticks to it.
Just to add to my solution: it needs a real good epoxy glue. I had to do it over as the glue did not harden enough. Last bit was from Bison, that was and still is perfect. Also make the rear of the strip a bit rough (sanding) to get it to stick better. The plastic seems like PE and not much sticks to it.
Sorry, couldn't help myself...
#33
Addict
Rennlist Member
Rennlist Member
Join Date: Jul 2002
Location: Edmonton, Ab
Posts: 2,286
Likes: 0
Received 0 Likes
on
0 Posts
Found some of that 3M tape and will reset the reflector tomorrow. Thanks!