Need Adaptor - Fuel Rail Sensor
#18
Banned
Join Date: Feb 2002
Location: Ft. Lauderdale FLORIDA
Posts: 5,248
Likes: 0
Received 4 Likes
on
3 Posts
My problem is that I need an adaptor that will fit the end of the fuel rail and connect with the sending unit for the Nordskog digital gauge that I'm going to mount on my "A" pillar. The idea is to be able to monitor fuel pressure changes with rising manifold pressure [more on that later], which is going to be the second of the three gauges mounted here. I guess I need to find out what the threads on the Nordskog unit are; I know that someone here tipped me off to these cool black-out digital gauges...
N!
N!
#20
Rocket Pilot
Rennlist Member
Rennlist Member
Join Date: Apr 2004
Location: gettysburg pa.
Posts: 3,298
Likes: 0
Received 0 Likes
on
0 Posts
Rcoble, do you have a wiring plan in mind for the gauge? I wanted to install mine but a little skiddish about a hot wire right there near the fuel rail tap.
#21
Instructor
Thread Starter
Join Date: Jun 2005
Location: Ojai CA
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
As far as the wiring plan, I was going to use good practice for the aplication. After all, each injector is getting juce right under the rubber injector hoses. I will run the cable along with the injector wiring.
I was wrong about the adaptor I need. I do need a female to female adaptor for my 83. So the autometer part won't work in my case ... any Ideas?? I think I looked at so many pictures of other peoples engine bays I forgot what mine looked like! I was sure the fuel rail had a female end.
I was wrong about the adaptor I need. I do need a female to female adaptor for my 83. So the autometer part won't work in my case ... any Ideas?? I think I looked at so many pictures of other peoples engine bays I forgot what mine looked like! I was sure the fuel rail had a female end.