In need of 3 1/2" Aluminum elbow
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
In need of 3 1/2" Aluminum elbow
I'm in need of a 3 1/2" OD aluminum elbow to fab up a cold air intake for my twin screw install. Anybody know where I can get one?
Thanks
Thanks
#2
Three Wheelin'
Join Date: Mar 2006
Location: San Diego / Las Vegas
Posts: 1,813
Likes: 0
Received 0 Likes
on
0 Posts
#4
Trending Topics
#9
Captain Obvious
Super User
Super User
Rather then ordering online and guessing if you get what you are looking for, there is a lot easier way to get pipes like this. Just go to your local truck repair shop (Mack, Peterbuilt, etc.) They will have mandrel bent exhaust pipes and elbows in stock.
While building my supercharger system, I bought a 3.5” 90 degree elbow at the local Mack dealership, $35cdn. There was enough straight section left over to fabricate an oil catch can.
While building my supercharger system, I bought a 3.5” 90 degree elbow at the local Mack dealership, $35cdn. There was enough straight section left over to fabricate an oil catch can.
#12
Captain Obvious
Super User
Super User
Originally Posted by bd0nalds0n
I had a hard time finding 3.5" at the truck places in San Diego. Seemed like they thought it was an uncommon size down here.
#14
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Originally Posted by Lance J
Were tony? i need all 3" to run my charge side for my intercoolers. Please p.m. the name of your local guy
The plane sheet squares i needed for other fab. i got locally...i will try and dig up the name for you