When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
fantastic news : I was able to repair my injector.
I did what you said : I put injector in carburettor cleaning fluid for about 2 hours,
Then, I let it spray on my test bank and after 5 times pumping it sprayed beautifully and did not leak anymore
modified hydraulic car lifter for testing CiS injectors.
Nice reconfiguration of a bottle jack. Do you have a write up of the steps to the conversion to an injector tester?
Nice reconfiguration of a bottle jack. Do you have a write up of the steps to the conversion to an injector tester?
I do not really have a write-up but here is a summary of what I did :
1. I bought a bottle jack (brand LOTUS) for about 25$
2. I unscrewed the lid where the cylinder comes out of the jack
3. I removed the cylinder
4. In the hole of the lid, I tapped thread for putting the manometer onto it
5. drill a hole at the sidewall of the jack
6. also tap thread in this hole for putting a tube in it for the supply of fuel via a little reservoir
7. at the manometer side, you should put a little tap and injector line.
The tap is necessary to built pressure the first time you operate the jack with fuel so that you can fill up the jack completely with fuel
8. when operating the jack, you will see that once pressure reaches about 3.7 bar (53 psi) , the injector will open
05-25-2019, 01:55 PM
