Ken

Hello, I'm just throwing this out there in case anyone can help. I've been trying the past week to figure out how to mount an OMP RS seat into my 944. The OMP mounts didn't work because they are 14" between the holes, not the 16" needed for Porsches. I got a set of the Brey Krause parts which were supposed to adapt a Sparco Evo2 seat to the Porsche distance. The bolt patterns on the side of the seats were the same, so we gave them a try but they don't work. The seat width of the Sparco must be different. Here's the problem. If i had another set of the Brey Krause adapters, I could use two left side brackets on the drivers side seat and the distance would be correct. I flipped one of the brackets I have, but the mounting holes for the seat aren't symetrical when you flip them. If anyone can get another set for me tonight in the NYC area, I'll drive over and pick them up. I need all this because the Regional Autocross is tomorrow and i was hoping to kick butt in my new seat! If anyone can help, please call me at XXX(removed). Thanks!

Edit: Part # R-9060 might work too.

Wormhole

I am selling the Brey Krause 9060, and will be at zone 1. LEt me know if you want me to bring it.

adrial

You may be faster than me Ken, but I'm gonna blow smoke all over your car!! muahahahaha

How do you feel about helping me pull the engine?

Ken

Any idea if it will fit the OMP RS? The seat appears to be 16" wide at the side mounts. If you bring it, I'll try and take some measurements and see if they fit.

Hehe, who do you think you are, Spy Hunter? I could lend you a hand with the engine. I've still got the hoist. And for most of the winter weekends I should be free(except for figuring out this seat crap.)

adrial

Sounds good Ken...

You took your engine out the top, right?

I'm actually considering getting started early november...
Would that work OK for you?