PN for dowel pins between block and bellhousing?
09-12-2015, 07:05 PM
#16
Addict
Rennlist Member
Rennlist Member
Sorry for the delay, but I believe the best part number is N 022 301 1. Used two today that accounts for me finding them in their little plastic bag with the number on them.
The pins are 10 mm in diameter, right at 20 mm in length, nice taper for the end that fits in the block and the convex contour for the bellhousing end. The dowels I was talking (incorrectly) about before are to center the torque tube on the bellhousing.
Hope it's not too late for this to help you.
The pins are 10 mm in diameter, right at 20 mm in length, nice taper for the end that fits in the block and the convex contour for the bellhousing end. The dowels I was talking (incorrectly) about before are to center the torque tube on the bellhousing.
Hope it's not too late for this to help you.
