I just got a set of aftermarket seats for my 86 951 and i forgot about the belts being attached to the factory seats. On my 924S the receivers are attached to the center console and i just assumed it was the same in the later cars.

Anyway, it doesnt seem possible to mount the receivers to the new seats, so is it possible to mount them to the center tunnel in the later cars? Has anyone done it?

Would it be easier to just get a rollbar/harness setup? And what would that involve?

Thanks

 

IIRC there is at least 1" of clearance between the trans tunnel and the torque tube, you should be fine to drill and have room for a retaining nut on the back (use a locking nut!).