Tie rod end removal
02-24-2014, 05:00 PM
#16
Intermediate
Join Date: Nov 2011
Location: Asheboro, NC USA
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
I use a hammer as shown in the video and mentioned by others. I learned that from a front end mechanic that had years of experience.
I've owned a pickle fork or two, it ruins the seal and will not always work. I also have tried a puller with very little success, I have one now, it's junk. Pounding on the nut screwed on the threads will
damage the threads.
Clifton
I've owned a pickle fork or two, it ruins the seal and will not always work. I also have tried a puller with very little success, I have one now, it's junk. Pounding on the nut screwed on the threads will
damage the threads.
Clifton
02-24-2014, 07:13 PM
#17
Rennlist Member
Join Date: May 2012
Location: 88 928 S4 in Dallas, TX
Posts: 319
Likes: 0
Received 2 Likes
on
2 Posts
Get this: http://www.harborfreight.com/3-4-qua...tor-99849.html
Make sure you back the nut out but leave it on so that you don't damage the threaded shaft.
Make sure you back the nut out but leave it on so that you don't damage the threaded shaft.
