Start--and go? The manual says so, but...
#16
Burning Brakes
Join Date: Nov 2002
Location: Atlanta, GA
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Dave Swanson
Actually, the temp gauge is not your barometer here. When you get the warm-oil-pressure reading, you can whomp on it at will. Cold idle will show 4+ bar oil pressure. Warm idle will show 2-3 bar oil pressure. Once that baby drops into operating range, flog it like the wild german beast it is.
Start and go right away, no full throttle, revs between say 2000 and 3500. After warm, spin it up baby.
I have 153k miles on the car and can't believe how it loves to run hard.
Actually, the temp gauge is not your barometer here. When you get the warm-oil-pressure reading, you can whomp on it at will. Cold idle will show 4+ bar oil pressure. Warm idle will show 2-3 bar oil pressure. Once that baby drops into operating range, flog it like the wild german beast it is.
Start and go right away, no full throttle, revs between say 2000 and 3500. After warm, spin it up baby.
I have 153k miles on the car and can't believe how it loves to run hard.
Last edited by ahofam123; 07-22-2003 at 05:38 PM.
#17
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
I start the motor, put my belt on, and let the car roll down the slight incline of the driveway. then i keep it close to 2000 for a few blocks (six close stop signs), then up to 3000, shift to second, and keep it between 2000 and 3000 for about 1/2 to 3/4 mile total, then go through the gears keeping it below 3500 till the temp guage moves up.
but i'm and old man so i dont punch it on the road much anyway. i just like young chicks seeing this ODB in a red sports car!
but i'm and old man so i dont punch it on the road much anyway. i just like young chicks seeing this ODB in a red sports car!