veleno

So I want to make sure that the speed and reference sensors are plugged into the right harness at the mounting bracket but I can't see any markings to indicate which goes to what plug. Is there an easy way to tell? I checked the bracket, wires, plugs and nothing tells me which is for the speed sensor or the reference sensor. I can see the markings on the housing so I know which sensor is what, but up top I can't tell what's suppose to be plugged where.

Any help is appreciated.

Yarf

This should help
http://www.clarks-garage.com/pdf-manual/ign-02.pdf

divil

The marks on the DME connectors are little tags wrapped around the cable - they can slide right down along the cable to where it's hard to see them.

StoogeMoe

Well, you have only two ways to put them on. If the car doesn't start, swap them.