944S temp sensor electrical connector location
 

Does anyone know where the electrical connectors are for the temp sensor? I want to ohm out my temp sensor but I can’t seem to find the silly connector / connectors. I have heard that they are somwhere on the fire-wall? Is this correct?

IPSC sends

I would check the temp sender values for the DME at the DME plug.

The gauge temp sender at the block.

Be back in a sec with the pin numbers.

Here's a cut from the manual:

http://boards.rennlist.com/upload/944S-temp-sender.jpg

Thank you very much that will help. I was hoping someone would know where the connectors are in the engine compartment because I wanted to check them for corrosion as well. I am getting some intermittent jumping in my temp gauge as well as the running hot phenomenon. I “figger’ that I can ohm check and clean the connector to verify the indicating system is good before I start draining coolant... especially since I now have all of the air out of the system.

IPSC sends