Inexpensive Roll Cage !! Anyone else interested ?
09-26-2002, 10:09 AM
#17
Racer
Join Date: Aug 2002
Location: Ric, VA
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Hereis a link to a LARGE pic file that has a prett good roll cage in it, it is a bolt in but...
<a href="http://www.wepc.us/two/IMG_1539.JPG" target="_blank">http://www.wepc.us/two/IMG_1539.JPG</a>
<a href="http://www.wepc.us/two/IMG_1539.JPG" target="_blank">http://www.wepc.us/two/IMG_1539.JPG</a>
09-26-2002, 12:42 PM
#18
Rennlist Member
Check this site out. Vehicle Craft did the cage in my car for teh PO. Nice work, it was the best part of the car.
[URL=http://www.vehiclecraft.com/pictures/Cust_cars/Stockton/index.htm]
Alan
[URL=http://www.vehiclecraft.com/pictures/Cust_cars/Stockton/index.htm]
Alan
09-26-2002, 01:27 PM
#20
David,
Yeah, Stuttgart Hause really diagnosed it wrong. They told me your engine was shot.
Then again... when they installed my boost controller, they didn't even hook it up properly, and ended up getting the lines to my wastegate switched, so the spring wasnt even opening... would have had the same affect if I welded the dumptube shut. No wonder my car was running full boost (~22PSI), and I blew a headgasket. I can't believe all the $ I gave them
Yeah, Stuttgart Hause really diagnosed it wrong. They told me your engine was shot.
Then again... when they installed my boost controller, they didn't even hook it up properly, and ended up getting the lines to my wastegate switched, so the spring wasnt even opening... would have had the same affect if I welded the dumptube shut. No wonder my car was running full boost (~22PSI), and I blew a headgasket. I can't believe all the $ I gave them
09-26-2002, 09:53 PM
#24
Right now my car is at Bill Gordons shop, in Greensboro. A fellow rennlister is doing my install... Clark Fletcher. Great guy... very knowledgable! I have been at the shop every minute I could spare between classes to assist and learn anything I can. We should have it all done tommorow, just a few wastegate issues to work out and the wiring for the MAF and ARC 2 computer to do. Can't wait!
09-26-2002, 10:11 PM
#26
Rennlist Member
Thread Starter
Elon,
Ask Clark when he thinks his internet garage site will be active again. It was the best source for technical articles on our cars I have seen, until his web site went down. Tell him we all can't wait to see it up again. Thanks.
Ask Clark when he thinks his internet garage site will be active again. It was the best source for technical articles on our cars I have seen, until his web site went down. Tell him we all can't wait to see it up again. Thanks.
09-26-2002, 11:33 PM
#27
I did ask him that a couple days ago actually. He said he's been busy and just hasnt gotten around to getting it back up. His is, however, taking a lot of pictures of my car, and is going to post them on his site for more references.
I'll get on him tommorow about getting it back online
I'll get on him tommorow about getting it back online
