Balance Shaft Sprocket (do you need tool P9200) Toolmaster?
06-23-2002, 09:38 PM
#1
Burning Brakes
Thread Starter
Join Date: Nov 2001
Location: San Francisco Bay Area
Posts: 1,199
Likes: 0
Received 2 Likes
on
1 Post
Balance Shaft Sprocket (do you need tool P9200) Toolmaster?
I'll be doing my front seals as well and noticed that the procudure calls for the P9200 Balance shaft pin spanner. I don't think this comes in toolmaster's kit (?), do I really need it or can I scrape by without it?
06-24-2002, 02:40 AM
#2
Race Director
Some people have used needle-nose pliers to hold the balance-shaft sprockets. You can also put a punch/big nail into one of the sprocket holes and use a pry-bar between that and your socket. Or you can make a pin-tool pretty easily.
06-24-2002, 09:56 AM
#4
Burning Brakes
Thread Starter
Join Date: Nov 2001
Location: San Francisco Bay Area
Posts: 1,199
Likes: 0
Received 2 Likes
on
1 Post
Thanks Danno; In case toolmasters kit doesnt come with it I can use a couple punches.
Dermass: I didn't see the pin spanner on toolmasters site, I could have glanced over it or perhaps he just hasn't updated yet. But if you almost absolutely sure then I'll expect it in the package
Dermass: I didn't see the pin spanner on toolmasters site, I could have glanced over it or perhaps he just hasn't updated yet. But if you almost absolutely sure then I'll expect it in the package
