Rod Bearing Clearance?
#1
Instructor
Thread Starter
Join Date: Feb 2008
Location: Boise, Idaho
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Rod Bearing Clearance?
I'm preparing to replace the rod bearings in my S2. I've looked through the online service manual, but have not had any luck finding the clearance specification. Anyone know, or can you point me to the appropriate page/spec chart in the manual? Thanks!
#3
Instructor
Thread Starter
Join Date: Feb 2008
Location: Boise, Idaho
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Hmmm. Didn't occur to me that the spec would be metric. Makes sense, of course, but obviously I'll have to do a conversion to use Plastigage.
PS - Should I apply the WARNING in your sig to those numbers?!?!?!
PS - Should I apply the WARNING in your sig to those numbers?!?!?!
Last edited by LeMans71; 11-04-2008 at 02:26 PM. Reason: Humor
#6
Addict
Rennlist Member
Rennlist Member
Join Date: May 2002
Location: Phoenix, AZ - NJ Runaway
Posts: 3,649
Likes: 0
Received 0 Likes
on
0 Posts