Front Control Arm Rear Mount Bushing. Defective part?
#16
Racer
Thread Starter
Join Date: Apr 2005
Location: Tallinn, Estonia
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
One bushing looks likes that now
I hammered the intruding part back in and made some locking notches to hold it in.
Just low quality part?
Does someone know how right part should look like (gaps in the rubber)?
When should I tighten the bolt that goes through that bushing? When car is sitting on level surface?
I hammered the intruding part back in and made some locking notches to hold it in.
Just low quality part?
Does someone know how right part should look like (gaps in the rubber)?
When should I tighten the bolt that goes through that bushing? When car is sitting on level surface?
Car is weekend track event car. Where I could get best 968 castor blocks or should I use something else?
#17
Rennlist Member
#18
Racer
Thread Starter
Join Date: Apr 2005
Location: Tallinn, Estonia
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts