Does anyone out there have dimensioned sketches of the special tools needed to replace a timing/balance belt on a 1986 944 ?
I know I will need two special thin wrenches and I think something to lock one of the gears in place. I plan to make my own tools. I have ordered a tension measuring device and belts.

Anything else ?

Sketches or prints can be sent to dbloyer@ciaccess.com

 

all you need is here my friend

http://arnnworx.com/

 

Here is a crude sketch of the thin wrench I made from a Craftsman tappet wrench (I heated it to red hot for the bends using a vise). My pin wrench is also homemade but I don't have a sketch of that one. If Mr. Arnnworx had marketed his tools 15 years sooner I would have bought them instead....

 

Thanks; that is exactly what I was looking for

 

IIRC you only need to modify the 7/8 end since the newer replacement rollers all use the same size hex...