zerMATT951

I thought I read somewhere a while back that someone had made some CNC aluminum sun visor clips? Can anyone help me out on this?

I'm only asking because I end up replacing my clips at least once/year because they get hot and "sag" from the Texas heat (car sits out in the sun at work during the day). I'm getting tired of my visors falling down until I can replace them again... I need a more permanent solution.

Suggestions anyone?

TIA

Strike-Force

Wow! If anyone makes these I'd want to buy two! Never heard of this though, just of people nagging over the d*** little peices of plastic always breaking.

Travis - sflraver

I have some but I made them just for my car....

Epic2112

Well get to producing them then

Porsche-O-Phile

944Online has them.

Epic2112

Where, I don't see them on the page.

Epic2112

Nevermind I found them .

zerMATT951

I can't find them at 944online either... where did you find them?

inactiveuser92616

all I see on 944online is the sunroof latch pivot

my87944s

I just checked mine and they are some type of metal painted black... They appear to be fairly new and have no numbers stamped on them at all. It must have been something the PO did.

inactiveuser92616

we are talking about the piece you pop the sunvisor into and out of when you swing it towards the door and back again... right? I bought new ones, but they were plastic. So are there metal ones out there?

my87944s

YES, the ones in my car appear to be aluminum. I actually took one off this afternoon to see if there were numbers stamped on it and there are not. I assume it is aluminum only because of how light it is. If my wife gets back tomorrow with my camera, I will take a picture.

zerMATT951

Epic,

Can you tell me where on the page you found them 944online page you found them? I see aluminum sunroof parts, but no visor clips.

Thanks!

Epic2112

I was talking about the pivot.

pcarphanatik

Someone please make these!

Mine just fell apart in my hand while doing a gauge pod install