When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm currently in the process of replacing the head gasket on my 951 and found this pitting on the edge of the water jacket by the #1 cylinder. Is this something that's going to be a problem? I haven't seen any indication there was a problem in this part of the gasket.
Pulling the engine would be extremely difficult if it needs to be decked at a machine shop. I assume it would somehow need to be filled before doing so.
Is jb weld an option here? Should i just leave it as is?
Last edited by grandmas951; 06-25-2024 at 10:18 PM.