Solid-State Cooling Fan Relay
#21
Rennlist Member
Arrrgh! The Diagnostic version is already sold out.
Having diagnosed the darn things with a jumper per the instructions on “Clark’s” in the past... I was looking forward to your releasing this...hope you make more!
Having diagnosed the darn things with a jumper per the instructions on “Clark’s” in the past... I was looking forward to your releasing this...hope you make more!
The following users liked this post:
Tiger03447 (08-10-2021)
#22
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Thread Starter
- Joe
__________________
http://www.ftech9.com/
http://www.ftech9.com/
The following 2 users liked this post by Ftech9:
Millermatic (08-08-2021),
Tiger03447 (08-10-2021)
#23
Rennlist Member
Sold! Thank you.
#24
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Thread Starter
- Joe
Last edited by Ftech9; 08-09-2021 at 06:24 PM.
#25
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Thread Starter
I just want to give everyone an update,
I was expecting to sell a few of these, but it took only 3 days to sell out of every Fan SSR I could build. At this point, I have everyone's order nearly ready to go and I expect to ship tomorrow. I was hoping to ship earlier, but there was too many to build and the Diagnostics version takes significantly more time. Overwhelmingly, the Diagnostic version was preferred over the standard Fan SSR.
I would like to thank the Beta testers, especially Tom Pultz, for all the hours of testing and feedback.
Regards,
Joe Baumbach
I was expecting to sell a few of these, but it took only 3 days to sell out of every Fan SSR I could build. At this point, I have everyone's order nearly ready to go and I expect to ship tomorrow. I was hoping to ship earlier, but there was too many to build and the Diagnostics version takes significantly more time. Overwhelmingly, the Diagnostic version was preferred over the standard Fan SSR.
I would like to thank the Beta testers, especially Tom Pultz, for all the hours of testing and feedback.
Regards,
Joe Baumbach
The following 5 users liked this post by Ftech9:
dbonds (08-13-2021),
J1NX3D (08-12-2021),
Millermatic (08-12-2021),
mwc951 (08-12-2021),
SeaCay (08-12-2021)
#28
Addict
Rennlist
Lifetime Member
Rennlist
Lifetime Member
Yes, there are more scheduled for the next production cycle. Joe's waiting on the next batch of enclosures to be manufactured. Obviously, these are relatively small production runs so one can understand if the vendor doesn't produce a whole slew of them, not knowing how successful they will be. The good news is they were really successful
The following users liked this post:
J1NX3D (08-13-2021)