38D

So I am about to embark on this, but have a few questions.

Can I remove the warm up regulator too? Anything special that need to be blocked off when I do that?



The hose that comes off the left of my decel valve goes who knows where into the engine bay (see below). Any thoughts on how to block this off?



I read the suggestion on using a rubber plug with a nut. I assume that this will work for the hole on the intercooler as well.

JoeMag

...how are you going to control control pressure if you take that off?

38D

So I guess that means I need it

38D

Ok, so I have the decel valve out. Now I need to block off the holes. I am planning to use the rubber expansion method for intercooler, intake and warm up regulator. But what do I do with the line that goes to the top of the BOV valve (T junction from the small line that goes to the warm-up reg.).