Locking Sheet Metal screws
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: Feb 2004
Location: SW Ontario canada
Posts: 882
Likes: 0
Received 0 Likes
on
0 Posts
Locking Sheet Metal screws
Hope this isn't a dumb question:
I have both door panels off, and discovered while removing them that all the sheet metal screws and machine screws were loose to some degree or another. This is after I tightened them late last year.
I know what to do about the machine screws, but what works best on the sheet metal screws? The holes are good and not stripped. I'm not sure Loc-Tite will do it because of the limited thread contact in sheet metal.
Any ideas appreciated, as always.
I have both door panels off, and discovered while removing them that all the sheet metal screws and machine screws were loose to some degree or another. This is after I tightened them late last year.
I know what to do about the machine screws, but what works best on the sheet metal screws? The holes are good and not stripped. I'm not sure Loc-Tite will do it because of the limited thread contact in sheet metal.
Any ideas appreciated, as always.