Grill Badge Placement
#1
Rennlist Member
Thread Starter
Grill Badge Placement
Is there a "proper" location for the grille badge on the early cars??
I have a 2.7 badge I'll install. Its a sticky tape one note a bolt one...
Is this "right"?
Not that I care too much... which is why I'm asking here and not on Early911 where it may turn into a 30 page debate :-)
I have a 2.7 badge I'll install. Its a sticky tape one note a bolt one...
Is this "right"?
Not that I care too much... which is why I'm asking here and not on Early911 where it may turn into a 30 page debate :-)
#3
Rennlist Member
Thread Starter
Unstuck? I don't know. I have some 3m ceramic double sided tape that is designed for this sort of application. Its held the gurney lip on my 997RS at 150MPH and lots of sun and heat.
We shall see! :-)
#5
Rennlist Member
Thread Starter
71
i don’t need it correct. Just wanted a bit of flair. And in a more or less appropriate location.
i don’t need it correct. Just wanted a bit of flair. And in a more or less appropriate location.
#7
Rennlist Member
Thread Starter
Cool thanks
Trending Topics
#8
Rennlist Member
Thread Starter
This will do
#12
Rennlist Member
Thread Starter
#13
I bought my 3.2 badge from Patrick Motorsports when it was on sale. It's held in place with 2 long bolts that feed thru the grill. The guys over at car-bone.pl also make some great products too. Your choice - can't go wrong with either.
Patrick Motorsport badges
Car-bone.pl badges
I'll post a picture of my badge when I get a chance
Last edited by Ok Here We Go; 06-17-2019 at 06:42 PM.
#15
Rennlist Member
Thread Starter
That’s like 100hp there!