Hooray I'm in a great mood! :)
#1
Three Wheelin'
Thread Starter
Join Date: Nov 2001
Location: Livermore, California
Posts: 1,781
Likes: 0
Received 0 Likes
on
0 Posts
Hooray I'm in a great mood! :)
I got the bearings, hubs, drive axles, etc. all back together. All I need now is putting the rear shocks and springs in and hook up the stablizer.
Interesting fact:
Everybody I asked said that you couldn't get the left (from behind the car) drive axle in or out of the trailing arm without removing the starter or heat exchanger. Well somehow I did. All is well. Ready to go on an 8 hour trip.
<img src="graemlins/beerchug.gif" border="0" alt="[cheers]" />
Interesting fact:
Everybody I asked said that you couldn't get the left (from behind the car) drive axle in or out of the trailing arm without removing the starter or heat exchanger. Well somehow I did. All is well. Ready to go on an 8 hour trip.
<img src="graemlins/beerchug.gif" border="0" alt="[cheers]" />
#2
Three Wheelin'
Thread Starter
Join Date: Nov 2001
Location: Livermore, California
Posts: 1,781
Likes: 0
Received 0 Likes
on
0 Posts
Hooray it is done
All new shocks, springs, bushings, bearings, some seals, brake master cylinder (decided to buy new 19mm). It's 12:30 right now so I'm not going to try it out just yet due to noise pollution etc.
<img src="graemlins/beerchug.gif" border="0" alt="[cheers]" />
All new shocks, springs, bushings, bearings, some seals, brake master cylinder (decided to buy new 19mm). It's 12:30 right now so I'm not going to try it out just yet due to noise pollution etc.
<img src="graemlins/beerchug.gif" border="0" alt="[cheers]" />