When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I doubt you'll find the exact size decal or stencils. I say that with a certain level of confidence because I undertook a similar project some years ago:
Andreas is correct, of course. I just measured Rennline's stencil, and while a very close match, it's approximately 3.25" wide. In comparison, the logos on my C2S calipers are about 3" wide.
Rennline stencil is a close match, but appears to be .25\" wider than the stock caliper logo
Andreas is correct, of course. I just measured Rennline's stencil, and while a very close match, it's approximately 3.25" wide. In comparison, the logos on my C2S calipers are about 3" wide. Rennline stencil is a close match, but appears to be .25" wider than the stock caliper logo
Thanks Jim. Yes, I purchased the Rennline stencil, as well as various decals from other suppliers. None were the correct size.
So I had a set of decals made - as discussed in my thread.
Decals/stencils should be 75mm x 5.5mm IIRC. 3” is pretty close. 3.25” is too big. I got mine from acromann. They make them overseas from high temp vinyl but any competent sign/printing shop should be able to make them.
Thanks Jim. Yes, I purchased the Rennline stencil, as well as various decals from other suppliers. None were the correct size.
So I had a set of decals made - as discussed in my thread.
Andreas
Yup, your thread was the inspiration for this project last winter. Just a rattle can job with VHT Caliper Paint, nothing compared to your holy grail of powder coating and zinc plating I was just about to paint the decals...
Yup, your thread was the inspiration for this project last winter. Just a rattle can job with VHT Caliper Paint, nothing compared to your holy grail of powder coating and zinc plating I was just about to paint the decals...
Boy for rattle can they look pretty good... Looks like you took time to prep them.... good job. You're going to be competition soon.. LOL
Decals/stencils should be 75mm x 5.5mm IIRC. 3” is pretty close. 3.25” is too big. I got mine from acromann. They make them overseas from high temp vinyl but any competent sign/printing shop should be able to make them.
... and significantly affects brake performance!
At 5 feet away, my calibrated eye screams inside my head and wants to pop out due to the extra 1/8" top and bottom of the sticker script!
See what I mean! ...and this is with the wheel off!
Imagine how much further it would be accentuated with a wheel on!
10-03-2017, 06:54 PM
Caliper Porsche Logo
I was just about to paint the decals...
...and this is with the wheel off! 