My 911 build
#31
wow...not sure how i missed this thread...very nice! can't wait to see it when it's done!
#32
Rennlist Member
Thread Starter
Jonathan and I are back at it on Sunday and the plan is:
1. engine and transmission should be going in
2. Singer headlights should be installed
3. Rear wiring will be cleaned up and remounted
4. Linkage cable for heater boxes should be attached
5. Perhaps we install the new driveshafts
6. Attempt to install numerous bits and pieces of trim etc.
I'll snap more photos of the installation plus snap some of the interior and other shots.
1. engine and transmission should be going in
2. Singer headlights should be installed
3. Rear wiring will be cleaned up and remounted
4. Linkage cable for heater boxes should be attached
5. Perhaps we install the new driveshafts
6. Attempt to install numerous bits and pieces of trim etc.
I'll snap more photos of the installation plus snap some of the interior and other shots.
#33
Nordschleife Master
Jonathan and I are back at it on Sunday and the plan is:
1. engine and transmission should be going in
2. Singer headlights should be installed
3. Rear wiring will be cleaned up and remounted
4. Linkage cable for heater boxes should be attached
5. Perhaps we install the new driveshafts
6. Attempt to install numerous bits and pieces of trim etc.
I'll snap more photos of the installation plus snap some of the interior and other shots.
1. engine and transmission should be going in
2. Singer headlights should be installed
3. Rear wiring will be cleaned up and remounted
4. Linkage cable for heater boxes should be attached
5. Perhaps we install the new driveshafts
6. Attempt to install numerous bits and pieces of trim etc.
I'll snap more photos of the installation plus snap some of the interior and other shots.
#38
Rennlist Member
Thread Starter
Good to see you today Rick! Wow folks Rick has one badass 997! 4.0L insanity...Sounds the bomb.
Progress today:
-Engine and transmission mated and all wiring hooked up.
-Singer headlight wiring is in
-rear wiring bracket installed in engine bay
-taillight housings ready to be installed once we get new hardware
-Access to fuel pump removed to be swapped out Thursday night
Progress today:
-Engine and transmission mated and all wiring hooked up.
-Singer headlight wiring is in
-rear wiring bracket installed in engine bay
-taillight housings ready to be installed once we get new hardware
-Access to fuel pump removed to be swapped out Thursday night
#39
Rennlist Member
Thread Starter
#40
Rennlist Member
Thread Starter
All wired and plumbed!
#44
Rennlist Member
Thread Starter
Correct! It's all about finding the right car...