Misc. 968 Parts for Sale
#1
Drifting
Thread Starter
Misc. 968 Parts for Sale
Hey all, I have a few parts to sell. Ask any and all questions. BRO + Shipping accepted.
I would say all these parts need a little work, and honestly not sure if they have value to anyone.
These cam covers where just taken off my car, it works as is. Top cover is perfect other than paint peeling, no warping. The bottom cover's studs, where the top cover attaches looks like it has been re-threaded with a heli-coil and starting to crack and looks like expanded up. So bottom cover would have to be repaired. Sold as a set. Would like to get $150
These covers, again taken off my car, have cracks in a couple spots, could be plasti welded easily and made to be a good rear and middle cover set. $50 for the pair
This variocam tensioner, was removed, I was told when it was retracted, it was difficult and was advised to replace it. Not sure if these can be rebuilt.
Last is a roller, brand new, less that 200 miles on it it was covered in belt dust. Shop that messed up my belt job replaced it at my insistence.
I would say all these parts need a little work, and honestly not sure if they have value to anyone.
These cam covers where just taken off my car, it works as is. Top cover is perfect other than paint peeling, no warping. The bottom cover's studs, where the top cover attaches looks like it has been re-threaded with a heli-coil and starting to crack and looks like expanded up. So bottom cover would have to be repaired. Sold as a set. Would like to get $150
These covers, again taken off my car, have cracks in a couple spots, could be plasti welded easily and made to be a good rear and middle cover set. $50 for the pair
This variocam tensioner, was removed, I was told when it was retracted, it was difficult and was advised to replace it. Not sure if these can be rebuilt.
Last is a roller, brand new, less that 200 miles on it it was covered in belt dust. Shop that messed up my belt job replaced it at my insistence.
Last edited by touareg; 02-15-2017 at 12:12 PM.
#2
Three Wheelin'
Join Date: Jul 2009
Location: Hawkinsville / Perry, Georgia, RETIRED USAF GO BLUE
Posts: 1,309
Likes: 0
Received 1 Like
on
1 Post
I looked and looked but could not find a price on any of your for sale parts.
Dibs on the roller and belt tensioner if the price is right.
Cheers,
Larry
Dibs on the roller and belt tensioner if the price is right.
Cheers,
Larry
#3
Drifting
Thread Starter
Not sure if you read my other thread on the failed belt job I had, the but balance shaft belt was rubbing against a dropped bolt, and there was belt material all over the place.
That timing belt roller, while probably OK is dusty.
The tensioner is original to the car, 150k. Again, since I was getting all this work done on my cam and heads, decided to just replace it as it as I was told it was difficult to retract, do not know if that is indicative of anything.
Full disclosure and all that!
#5
Drifting
Thread Starter
Not sure if you can send me a PM yet, I will send you one and you can maybe respond with your email address.
Thanks!