Interior LED Bulb Upgrade 991 911 (Video)
#1
Rennlist Member
Thread Starter
Interior LED Bulb Upgrade 991 911 (Video)
Another quick video on upgrading your old school bulbs with LED
Super easy, and highly recommended
Super easy, and highly recommended
#2
Nice video Franko I replaced all my regular bulbs with LEDs in January. The door light assembly lenses need to be removed completely. I used tape around the leather to prevent marring. The light is removed from the back side and pull straight out from the twist style base. Thx for sharing.
#3
Nordschleife Master
Franko - any T10 194 LED bulb will work?
#4
Rennlist Member
Thread Starter
Pretty much, just remember the doors need a shorter one. Here is what I used, https://www.amazon.com/GENSSI-Interior-Replacement-Miniature-CANBUS/dp/B01FRL0LP0
Try to get a half decent one so it doesn't burn out fast and is bright.
Try to get a half decent one so it doesn't burn out fast and is bright.
#5
Here is the before and after bulb to LED replacement for the interior door lights. Here is the website where I purchased the LEDs.
http://store.ijdmtoy.com/5-SMD-T10-L...s-p/10-011.htm
http://store.ijdmtoy.com/5-SMD-T10-L...s-p/10-011.htm
#6
Nordschleife Master
Thanks!
#7
Burning Brakes
Nice video Franko I replaced all my regular bulbs with LEDs in January. The door light assembly lenses need to be removed completely. I used tape around the leather to prevent marring. The light is removed from the back side and pull straight out from the twist style base. Thx for sharing.
Correct?
TIA
Also, have any of you looked into doing the same for the sun visors and small lights up near the rear view mirror.
Finally,
Awesome video. Thank you
Trending Topics
#8
OK so.... as I am looking at this and as I understand it, use a flat blade screw driver or small trim removal tool and slide it UP into the small slot on the bottom of the light assembly and then gently pry the entire light and lens cover OUTWARD away from the door.
Correct?
TIA
Also, have any of you looked into doing the same for the sun visors and small lights up near the rear view mirror.
Finally,
Awesome video. Thank you
Correct?
TIA
Also, have any of you looked into doing the same for the sun visors and small lights up near the rear view mirror.
Finally,
Awesome video. Thank you
BTW: If you happen to remove the clear and red lens without the housing, don't be alarmed. The lens will snap on providing you don't break it. Good luck.
#11
Rennlist Member
Thread Starter
#14
Racer
Have a set of good interior trim tools such as this one:
https://www.amazon.com/Motivx-Tools-...ior+trim+tools
1. Using a thin trim tool to gently remove the sides of each interior light.
2. Gently squeeze both ends together to remove the light housing from the car.
3. Squeeze down on the electrical connector to separate it from the light housing.
4. Swap and replace the bulbs (once it has cooled off, or wear gloves).
That's it.