GT3 RS side decals
#16
Rennlist Member
Did you go OEM or Suncoast? Asking because Suncoast decal is from the 997.1 GT3 RS that has a 4" shorter wheelbase and your decal looks like it covers the full length between wheel openings, which suggests Porsche has a longer decal for 991 RS. If one were using the 997.1 RS decal on the 991.1 RS there'd be an extra 4" of space between the wheel openings and that doesn't appear to be the case in the case in the photos below.
#17
I guess the factory doesn't put the rear quarter clear film on cars with the side decals. I'm not sure how the mat decals will look with a clear film over them compared to the door without. Something to think about if you are going this route.
#19
Mine has taken a few hits already so I'll likely have to replace it as some point anyway. Unfortunately they like to gravel roads in the winter and chip-seal roads in the summer and it never clears off 100%.
#22
Racer
Take a look here,at around page 3 you will find all measures to place decals like stock.
https://rennlist.com/forums/991-gt3-...ng-decals.html
https://rennlist.com/forums/991-gt3-...ng-decals.html
#23
Rennlist Member
I paid $228 a side just for the script, front and rear bumper was $80ea per side. Then had suntek film installed over everything.
I talked with ki studio and he mentioned the top of the script might differ slightly from oem, I went oem.
Part#s for script below
I talked with ki studio and he mentioned the top of the script might differ slightly from oem, I went oem.
Part#s for script below