When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
We are getting very close to re installing this engine back into the car, We were waiting for some special injectors and we will also make up a new engine harness.
how many Valets does it take to figure out that YES that little R is in the right spot...... still managed to almost reverse in to a Benz.... but i did get a parking spot up front with the range rover and 458.
Rob, sorry to tell you Hochleistung is misspelled. Pictures from 1986 when I had acquired the first Strosek car from Germany. I still keep it in the garage but not drivable at the time being.
Åke
Last edited by Strosek Ultra; 07-07-2016 at 11:17 AM.
This is how I discovered a front ball cup bushing failure mentioned in my intro post late last week. There is a section that we travel on our way home from work (my wife and I commute together when possible) where I hit the accelerator on the aggressive side in 3rd through some tight corners, then upshift to 4th to 5th. On this particular day, as I went to 4th, the shifter went WAY too far forward. I knew something was wrong. This was literally the day prior to leaving for vacation. My wife wasn't a bit amused with the delay getting home! $14 and a couple of broken knuckles and I was back in business...I am a newbie and learning.
07-02-2016, 11:28 AM
