Rennlist - Porsche Discussion Forums - Search Results

Notices
 
Search: Posts Made By: Kevin
Showing results 1 to 25 of 499
Search took 0.53 seconds.
Yesterday, 10:50 PM
Replies: 15
Views: 405
Posted By Kevin

No..

No..
Yesterday, 10:47 PM
Replies: 4
Views: 181
Posted By Kevin

Word of caution >> you cannot couple (without...

Word of caution >> you cannot couple (without extreme wear/damage) a non sprung clutch disk with a lightweight non dual mass flywheel. You will destroy your input shaft bearings.
If your clutch...
Yesterday, 06:37 PM
Replies: 8
Views: 490
Posted By Kevin

Over the years when you have spoilers and...

Over the years when you have spoilers and difference panel piece painted> I have found that Glasurit is good for Black.. However I went thru 5 different paint companies to nail down Polar silver. ...
Forum: 991 Turbo
Yesterday, 05:05 PM
Replies: 38
Views: 2,603
Posted By Kevin

You need to realize that the compressor housings...

You need to realize that the compressor housings are all different between each MARK level.. 997.1TT to 991.1 and Mark 2.. Porsche has ALWAYS changed the compressor cover on each model upgrade....
Forum: 991 Turbo
Yesterday, 02:15 PM
Replies: 38
Views: 2,603
Posted By Kevin

A few fun facts. Porsche decided to use the...

A few fun facts. Porsche decided to use the compressor stage (wheel) of the 997GT2/RS for the 997.2TT. I think that they wanted to consolidate design and testing for something off the shelf. ...
06-24-2019, 08:50 PM
Replies: 15
Views: 405
Posted By Kevin

The MAF eater airbox ate the MAF.

The MAF eater airbox ate the MAF.
06-23-2019, 04:09 PM
Replies: 5
Views: 424
Posted By Kevin

For the most comprehensive Kit" is the factory...

For the most comprehensive Kit" is the factory installation of GT2/GT3 clutch slave components. Go to my clutch page and look at the hardware involved.
...
06-22-2019, 07:54 PM
Replies: 58
Views: 6,004
Posted By Kevin

I can arrange that.. LOL

I can arrange that.. LOL
06-22-2019, 07:52 PM
Replies: 8
Views: 721
Posted By Kevin

Replace the wideband O2's (preCat) Pull the...

Replace the wideband O2's (preCat) Pull the hoses to your intercoolers and check for oil (should drain out).. If more than a cup, pull intercoolers and preturbo tubing and clean with soap and...
06-22-2019, 07:49 PM
Replies: 6
Views: 873
Posted By Kevin

I'm selling a fresh 996GT2/4wd gearbox...

I'm selling a fresh 996GT2/4wd gearbox (exchange)… Full modular 993RS mainshaft and gears with 3 piece steel syncro. 1st, 2nd, 3rd (wide CUP) 4th taller ratios 5th is stock with RUF 6th (overdrive)...
06-21-2019, 07:01 PM
Replies: 6
Views: 873
Posted By Kevin

Thank you.. I have a polished crank (std/std)...

Thank you.. I have a polished crank (std/std) less than 16K miles on it to with the rods. I have 3 engine cases for anyone that wants to swing out a engine build.. LOL
06-21-2019, 02:44 PM
Replies: 58
Views: 6,004
Posted By Kevin

Back to the original "programming" here is the...

Back to the original "programming" here is the same Stage 2 turbochargers that Lance has at the track running on race gas (10 to 12 years ago).. ...
06-21-2019, 02:30 PM
Replies: 6
Views: 873
Posted By Kevin

I have another set of 993/993TT/996TT/997TT Arrow...

I have another set of 993/993TT/996TT/997TT Arrow rods in stock. Fitted with the large ARP rod bolts.
06-21-2019, 02:20 PM
Replies: 40
Views: 3,913
Posted By Kevin

This ad struck me... Look at the damage to the...

This ad struck me... Look at the damage to the front spoiler and his reply to look elsewhere. All for $80K
...
06-17-2019, 11:15 PM
Replies: 6
Views: 617
Posted By Kevin

My recommendation is to look for tuning that...

My recommendation is to look for tuning that incorporates PDK and Engine tuning and the ability to datalog and write tuning files based on the data produced.
06-17-2019, 07:19 PM
Replies: 16
Views: 1,028
Posted By Kevin

300V 0W40.. But what are you ambient temps now?...

300V 0W40.. But what are you ambient temps now? 5W50 shines in the extreme heat. 90 to 110F(I'd leave the 5W50 in and change it before 3K miles and have your oil tested for viscosity at 3K)
06-17-2019, 07:09 PM
Replies: 16
Views: 1,028
Posted By Kevin

Mixing 5W50 with your current 0W40 or 5W40 does...

Mixing 5W50 with your current 0W40 or 5W40 does work.. Motul fans should look at the Motul 5W50 Sport oil It is a "better" more premium oil vs the Xcess formulation. It is closer to 300V with more...
06-17-2019, 06:38 PM
Replies: 11
Views: 1,079
Posted By Kevin

Track DE work should include a splash of race...

Track DE work should include a splash of race gas...

In this particular "car" the knock retard on the factory stock file (verified original) had higher than normal knock retard running on 98RON.....
06-17-2019, 04:27 PM
Replies: 5
Views: 392
Posted By Kevin

Was your traction control flashing? Wheel spin...

Was your traction control flashing? Wheel spin is limited with rear brake engagement

Regardless >>age is creeping up on our cars. I'd change the fluid...
06-17-2019, 01:56 PM
Replies: 58
Views: 6,004
Posted By Kevin

Lance, Thanks for the "almost" 8 years update. ...

Lance, Thanks for the "almost" 8 years update. Your original install thread is here:

https://rennlist.com/forums/996-turbo-forum/670594-umw-stage-2-turbo-installation-completed-3.html

Again...
06-16-2019, 04:46 PM
Replies: 16
Views: 1,028
Posted By Kevin

How much monies do you want to spend to eliminate...

How much monies do you want to spend to eliminate the engine noise? That's the real question. It's not a simple fix or cheap fix. What were the quotes to go into your engine?

The first thing...
06-16-2019, 01:27 PM
Replies: 11
Views: 1,079
Posted By Kevin

Post your last run. Knock retard is 6 points...

Post your last run. Knock retard is 6 points lower.. Throttle plate, fueling, boost, knock retard does require adaptation. If infact you have "quality" 98 RO in your fuel tank, you should see...
06-16-2019, 12:52 PM
Replies: 11
Views: 1,079
Posted By Kevin

Robert, I think that you need plugs. Your...

Robert, I think that you need plugs. Your timing should be lower with your 98 Ron. Email me your current log file with 98 Ron
06-12-2019, 03:25 PM
Replies: 8
Views: 940
Posted By Kevin

For a street driven Tippy with X50's.. Remove...

For a street driven Tippy with X50's.. Remove them and convert the turbine over to K16 frame size.
The tip needs early spooling to generate more torque for the tranny torque converter.
I have...
06-11-2019, 04:40 AM
Replies: 4
Views: 811
Posted By Kevin

Only if you are running a lightweight RS flywheel

Only if you are running a lightweight RS flywheel
Showing results 1 to 25 of 499
 


 
Forum Jump

Contact Us - About Us - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.