Rennlist - Porsche Discussion Forums - Search Results

Notices
 
Search: Posts Made By: jwillman
Showing results 1 to 25 of 499
Search took 0.44 seconds.
Forum: 928 Forum
04-29-2019, 10:44 AM
Replies: 8
Views: 484
Posted By jwillman

https://rennlist.com/forums/928-forum/336954-how-d...

https://rennlist.com/forums/928-forum/336954-how-do-you-remove-disassemble-the-hatch-upper-latch-now-hatch-rattle-fix.html
Forum: 928 Forum
04-15-2019, 04:54 PM
Replies: 8
Views: 388
Posted By jwillman

https://cimg3.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg3.ibsrv.net/gimg/rennlist.com-vbulletin/588x427/wire_shims_971bb475b6b3f647e60ff50cfa70ccc53fbad3b6.jpg
You need to use a pry bar back on the lower end of the release arm between the...
Forum: 928 Forum
04-03-2019, 09:31 PM
Replies: 18
Views: 733
Posted By jwillman

There are allot of more talented wrencher's than...

There are allot of more talented wrencher's than I that said they have done it. Even without getting the insert under the lip a new insert is better than no insert at all from a play and shift...
Forum: 928 Forum
04-03-2019, 08:51 PM
Replies: 18
Views: 733
Posted By jwillman

https://cimg5.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg5.ibsrv.net/gimg/rennlist.com-vbulletin/721x811/upper_relase_arm_socket_6ce0bb7d3d39ec286bfef274962aa41c98f75816.jpg
I have replaced it twice in my 79 and can't imagine getting enough...
Forum: 928 Forum
08-11-2018, 09:12 PM
Replies: 5
Views: 257
Posted By jwillman

You will have to pull the lower covers under the...

You will have to pull the lower covers under the steering column. Some seem to be able to access from there but I have always removed the four pod attaching bolts so I could raise the pod up to...
Forum: 928 Forum
08-10-2018, 08:38 AM
Replies: 5
Views: 257
Posted By jwillman

https://cimg3.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg3.ibsrv.net/gimg/rennlist.com-vbulletin/200x200/92834791900_0ec183278e56d6eea0b28e101eac9792777691c6.jpg
I had the same issue. The ignition switch has two parts, the back half is the...
Forum: 928 Forum
08-10-2018, 08:06 AM
Replies: 4
Views: 362
Posted By jwillman

My early car does not have this bearing bracket...

My early car does not have this bearing bracket assembly. Not sure when it was added.
Forum: 928 Forum
08-09-2018, 08:38 AM
Replies: 13
Views: 398
Posted By jwillman

I had an still running issue that was tied to a...

I had an still running issue that was tied to a bad bulb controller.

https://rennlist.com/forums/928-forum/991745-car-continues-to-run-with-lights-on-and-ignition-switch-off.html
Forum: 928 Forum
08-02-2018, 11:35 PM
Replies: 6
Views: 437
Posted By jwillman

My hatch sat high like that for years until I...

My hatch sat high like that for years until I replaced the white plastic upper hatch latch piece that had worn over the years. Once I replace the part the hatch pulled down securely into place...
Forum: 928 Forum
07-06-2018, 05:02 PM
Replies: 40
Views: 2,803
Posted By jwillman

I have been using the Hayden digital fan...

I have been using the Hayden digital fan controller with the wrecking yard ford contour dual fans for the last few years. I bought and installed the optional brass sending unit that screws into the...
Forum: 928 Forum
06-15-2018, 04:58 PM
Replies: 4
Views: 236
Posted By jwillman

no relay - the red unit in second photo is a...

no relay - the red unit in second photo is a simple on off switch for compressor. The rest is controlled by simple electrical trace board, metal quadrants that control the vacuum module for the...
Forum: 928 Forum
06-07-2018, 04:17 PM
Replies: 5
Views: 360
Posted By jwillman

That seal does not look like that when new. See...

That seal does not look like that when new. See the following post.

https://rennlist.com/forums/928-forum/809516-cis-fuel-injector-reassebmly-installation.html
Forum: 928 Forum
04-07-2018, 11:18 AM
Replies: 7
Views: 564
Posted By jwillman

A harness from Porsche for $400. Did you buy one...

A harness from Porsche for $400. Did you buy one of those and from where? That sounds too good to be true.
Forum: 928 Forum
03-03-2018, 05:34 PM
Replies: 6
Views: 436
Posted By jwillman

I pulled the TT out of my 79 manual without...

I pulled the TT out of my 79 manual without dropping the transmission or clutch pack although I later had to drop the clutch to replace the upper release arm bushing before installing TT and in hind...
Forum: 928 Forum
02-08-2018, 09:23 PM
Replies: 2
Views: 309
Posted By jwillman

wow , guess the set I bought at $100 was a steal.

wow , guess the set I bought at $100 was a steal.
Forum: 928 Forum
01-01-2018, 10:57 AM
Replies: 13
Views: 2,355
Posted By jwillman

I recently pulled my rear bumper cover off and...

I recently pulled my rear bumper cover off and finally decided it was easier to snap off the threaded studs with a deep socket on an extension and some minimal lateral force rather than try all the...
Forum: 928 Forum
12-06-2017, 09:49 PM
Replies: 8
Views: 797
Posted By jwillman

I deleted the belt driven fans years ago and...

I deleted the belt driven fans years ago and installed the dual Ford Contour fan set up. I deleted the front AUX fan at the same time as the dual Ford fans both ran when the AC was on.

Recently I...
Forum: 928 Forum
12-06-2017, 06:27 AM
Replies: 5
Views: 586
Posted By jwillman

Thanks John. yes two of my marker light bulb...

Thanks John.

yes two of my marker light bulb opening weather boots are falling apart as are one of the front turn signal boots. Seems the only way to get them is buy a whole light assembly with...
Forum: 928 Forum
12-03-2017, 08:48 PM
Replies: 5
Views: 586
Posted By jwillman

Bump. Certainly I can not be the first owner...

Bump.

Certainly I can not be the first owner with dry rotted light assembly boots! Just need the right person to read this post.
Forum: 928 Forum
12-03-2017, 09:24 AM
Replies: 7
Views: 426
Posted By jwillman

Much easier on a 16V car. I pull the radiator...

Much easier on a 16V car. I pull the radiator out for more room. What will be the most time consuming is all the while you are at it stuff you may discover on your barn find once you pull the...
Forum: 928 Forum
12-01-2017, 08:09 PM
Replies: 4
Views: 349
Posted By jwillman

according to the 1979 owners manual. the right...

according to the 1979 owners manual.
the right side parking lights will be on with ignition off and turn signal lever in right turn position. left side on with ignition off and turn signal lever...
Forum: 928 Forum
12-01-2017, 04:38 PM
Replies: 5
Views: 586
Posted By jwillman

various light housing replacement weather boots

I have the side markers out all around and front bumper cover off the car. Many of the side marker and front turn signal, running lights and fog light electrical connector rubber covers are torn or...
Forum: 928 Forum
11-28-2017, 01:39 PM
Replies: 11
Views: 736
Posted By jwillman

The grinding "in a lot" of gears sounds like a...

The grinding "in a lot" of gears sounds like a clutch travel issue/ engagement issue and not necessarily just sloppy gear shift. There is a shift linkage rigging/ adjustment procedure in the WSM to...
Forum: 928 Forum
11-26-2017, 10:08 AM
Replies: 11
Views: 736
Posted By jwillman

https://cimg7.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg7.ibsrv.net/gimg/rennlist.com-vbulletin/275x183-1/ball_cup_14f464596a837bc10207ad4088605eede53878bc.jpg
When I did mine the first time with TT in the car I struggled as I could not...
Forum: 928 Forum
11-04-2017, 02:39 PM
Replies: 3
Views: 360
Posted By jwillman

Thanks, I will definitely be adding those on both...

Thanks, I will definitely be adding those on both ends this time around!
Showing results 1 to 25 of 499
 


 
Forum Jump

Contact Us - About Us - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.