Rennlist - Porsche Discussion Forums - Search Results

Notices
 
Search: Posts Made By: Mrmerlin
Showing results 1 to 25 of 483
Search took 0.55 seconds.
Forum: 928 Forum
Yesterday, 12:09 AM
Replies: 12
Views: 326
Posted By Mrmerlin

Rob Budd also does restitching and will use the...

Rob Budd also does restitching and will use the the original leather if its still in good condition.
about 300.00
Forum: 928 Forum
06-19-2018, 01:16 PM
Replies: 19
Views: 544
Posted By Mrmerlin

This thread ...................

This thread ...................
Forum: 928 Forum
06-19-2018, 08:57 AM
Replies: 19
Views: 723
Posted By Mrmerlin

I would add a master cylinder and new flex lines

I would add a master cylinder and new flex lines
Forum: 928 Forum
06-19-2018, 08:52 AM
Replies: 19
Views: 544
Posted By Mrmerlin

https://cimg6.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg6.ibsrv.net/gimg/rennlist.com-vbulletin/1500x2000/332_d53bc53a8fccf75d1d522b59abce4cbe3e359e06.jpeg
top to bottom,
the under the pod trim panel it covers the roll switches for the dash...
Forum: 928 Forum
06-18-2018, 10:53 PM
Replies: 21
Views: 490
Posted By Mrmerlin

if you follow the hose from the back of the fuel...

if you follow the hose from the back of the fuel pump to the bottom of the fuel tank do you see wires that plug into the tank? If so you may have a shorted intank fuel pump or the fuel pump relay is...
Forum: 928 Forum
06-18-2018, 10:47 PM
Replies: 1
Views: 155
Posted By Mrmerlin

sounds like a head gasket, or your getting oil...

sounds like a head gasket, or your getting oil into the combustion chamber and its burning in the cats.
First are you loosing oil or coolant?>
I would pull the plugs and see if any look like the...
Forum: 928 Forum
06-18-2018, 10:11 PM
Replies: 15
Views: 530
Posted By Mrmerlin

This sounds like a great adventure I am glad you...

This sounds like a great adventure I am glad you had the opportunity to go.

Pete look closer this is a Euro with flag mirrors and Cup 1 wheels it lives overseas.
It might be from the Frankfurt...
Forum: 928 Forum
06-18-2018, 12:44 PM
Replies: 11
oem
Views: 461
Posted By Mrmerlin

To get to the washer tank and 3 way connector,...

To get to the washer tank and 3 way connector, Jac...............oops wrong thread
Forum: 928 Forum
06-18-2018, 11:07 AM
Replies: 21
Views: 490
Posted By Mrmerlin

On your car Their are two CPS, NOTE they are...

On your car Their are two CPS,
NOTE they are both located at the rear of the V on the engine and the bell housing.
NOTE the one closest to the radiator is the one that will be used to run the...
Forum: 928 Forum
06-17-2018, 11:34 PM
Replies: 5
Views: 200
Posted By Mrmerlin

open the end cover for the wiper arm and tighten...

open the end cover for the wiper arm and tighten the 13mm nut.
NOTE depending on how long its been loose the arm may have its splines stripped out
Forum: 928 Forum
06-17-2018, 02:24 PM
Replies: 25
Views: 660
Posted By Mrmerlin

its the dirt that gets past it that you also dont...

its the dirt that gets past it that you also dont see, stick with the Factory filter,
you will never lose a race because you have a factory filter
Forum: 928 Forum
06-17-2018, 02:22 PM
Replies: 14
Views: 399
Posted By Mrmerlin

If your testing the compressor clutch and blowing...

If your testing the compressor clutch and blowing a fuse then the clutch is shorted to ground or your powering the ground wire
Forum: 928 Forum
06-17-2018, 02:19 PM
Replies: 23
Views: 571
Posted By Mrmerlin

did you ever inspect the 3 way junction under the...

did you ever inspect the 3 way junction under the right front fender? ,
they snap apart,
this would account for a fuel smell if your fuel lines are good
Forum: 928 Forum
06-16-2018, 09:44 PM
Replies: 5
Views: 177
Posted By Mrmerlin

Gomez Yes thats probably a better option.

Gomez Yes thats probably a better option.
Forum: 928 Forum
06-16-2018, 06:04 PM
Replies: 25
Views: 660
Posted By Mrmerlin

In addition to whats been posted above, the knn...

In addition to whats been posted above,
the knn filter also leaks dirt around the edges ,
(look at the lower aircleaner housing at the next knn filter you remove, bet you find sand in the oily...
Forum: 928 Forum
06-16-2018, 05:58 PM
Replies: 14
Views: 399
Posted By Mrmerlin

I really dont understand what your powering and...

I really dont understand what your powering and then blowing a fuse.
if you would post pictures it would clear up a lot of the mud.
You know clear as mud?

to check the compressor clutch you...
Forum: 928 Forum
06-16-2018, 02:36 PM
Replies: 5
Views: 177
Posted By Mrmerlin

the idea i had with pinning was to put a screw...

the idea i had with pinning was to put a screw into the tube thus the rubber doughnut of the damper will rest on it then the opposite end also gets a pin to prevent it from sliding,
I would not...
Forum: 928 Forum
06-16-2018, 09:17 AM
Replies: 5
Views: 177
Posted By Mrmerlin

Chris if the shaft is spinning freely then the...

Chris if the shaft is spinning freely then the bearings are probably done dryed out,
Best to swap in new bearings.

Also look for a sliding damper if its been installed,
if so it would be wise to...
Forum: 928 Forum
06-16-2018, 01:36 AM
Replies: 21
Views: 490
Posted By Mrmerlin

at this point best to clean the battery terminals...

at this point best to clean the battery terminals and replace the 3 running relays ,
Fuel pump, EZF and LH IIRC they are all 53 relays
Forum: 928 Forum
06-16-2018, 01:34 AM
Replies: 130
Views: 6,730
Posted By Mrmerlin

Looking good wish I was there, \ Have a great...

Looking good wish I was there,
\ Have a great weekend!
I have been working on cars still more to do
Forum: 928 Forum
06-15-2018, 09:51 PM
Replies: 17
Views: 548
Posted By Mrmerlin

NOTE if you have never used the tow hook it would...

NOTE if you have never used the tow hook it would be wise to read the owners manual first.

So, open the hatch
Then open the tool kit
Take out the tow hook.
Kneel down and screw it into the...
Forum: 928 Forum
06-15-2018, 05:51 PM
Replies: 8
Views: 184
Posted By Mrmerlin

that spindle and hub look terrible from...

that spindle and hub look terrible from corrosion,
now that its apart you might be better off sourcing parts in better condition,
That ABS sensor ring also looks bad.
Where is the backing plate?...
Forum: 928 Forum
06-15-2018, 05:45 PM
Replies: 14
Views: 399
Posted By Mrmerlin

The post at the pressure switch, is open to...

The post at the pressure switch, is open to ground.

what does this mean?



That switch thats screwed into the side of the receiver dryer will close when their is enough pressure in the system...
Forum: 928 Forum
06-15-2018, 04:56 PM
Replies: 4
Views: 320
Posted By Mrmerlin

Hey if Mommas happy, everyone is happy, Glad...

Hey if Mommas happy,
everyone is happy,
Glad your staying cool brother.


Mommas really happy so is everyone else!
watch this

https://youtu.be/RrbSHxXSdbc
Forum: 928 Forum
06-15-2018, 04:48 PM
Replies: 16
Views: 718
Posted By Mrmerlin

HTD = Hi Torque Drive, belt tooth designation...

HTD = Hi Torque Drive,
belt tooth designation for the round tooth belt
HTD« Timing Belts feature a curvilinear tooth profile, which is a design advancement over the standard trapezoidal shaped...
Showing results 1 to 25 of 483
 


 
Forum Jump

Contact Us Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.